Programmer PIC AVR eeprom

I made a programmer for AVR, PIC and EEPROM, I don’t use it now, but nevertheless, the design can be said to be a must have – simple and works from a COM port.

 The diagram was in the Radio magazine and on Radiokot, slightly modified.

 I have a few more words – R5 is not needed here, it causes an error – the transistor does not open and the controller does not switch to programming mode. 

 Here is the original diagram.

Here are the tables that you need to use to configure the programs.

 1. PonyProg. You should select the SI Prog I/O programmer and set the signal inversion according to Table 1.

 2. WinPic.

 3. IC-Prog

For the last two you should select JDM Programmer.

 Several photos of the repeated design.

 Download Full Project

Source Post: